June 26, 2012
One of the more promising solid state memory technologies on the horizon is Phase Change Memory (PCM). PCM has the potential to write data faster than current DRAM chips by charging atoms within a crystal. This has led some people to believe that the technology might enable the much-sought-after instantaneous computer boot-up. Ars Technica discussed the future prospects for PCM last week.
At the atomic level, PCM stores data in a compound of germanium, antimony and tellurium. When a voltage is applied to the atoms, they change into an ordered crystal. The data can then be deleted by melting the crystalline substance. To read the information, a computer determines the electrical resistance of the material.
An important attribute of phase change memory is that the technology is non-volatile. This means it does not require power to retain information like standard RAM offerings. Along with the possibility of replacing system memory, these chips might end up competing with NAND flash as well.
Some memory manufacturers are dabbling with PCM on a small scale. Micron offers phase change modules with densities up to 128 MB and Samsung inserted PCM into an unnamed cell phone, but ended up removing it later on.
Despite the benefits, PCM suffers from an inherent issue that has slowed its path to adoption. The biggest one is its write speed. Current DRAM technology can perform write operations within a 1-10 nanosecond window, which is faster than the time it takes for the germanium, antimony and tellurium compound in PCM to crystallize. Other crystalline compounds with faster reaction times have been researched, but they are not as stable as the current PCM design, slowly erasing themselves in low temperatures over time.
Recent research from the University of Cambridge has given hope to the new technology though. Stephen Elliott, Professor of Chemical Physics at the university, along with his colleagues, have discovered a method to improve PCM write speed.
By preparing the material with a 0.3-volt electrical current, crystallization occurred after receiving a 500-picosecond burst of 1 volt. Essentially, the low current made the material act like water at near-freezing temperatures. A few crystalline seeds formed, enabling the material to change at an accelerated rate when receiving additional voltage. The improvement was ten times faster than similar compounds that were tested and remained stable for 10,000 write-rewrite cycles.
The need for extra electrical current during the write cycle could become an Achilles heel for phase change memory, however, since that’s going to increase the overall power draw. It’s a relatively new development though, and further optimizations may be under development. If the price point and power consumption are competitive, PCM may indeed replace one or more current memory technologies.
Full story at Ars Technica
In quieter times, sounding the bell of funding big science with big systems tends to resonate further than when ears are already burning with sour economic and national security news. For exascale's future, however, the time could be ripe to instill some sense of urgency....
Read more...
In a recent solicitation, the NSF laid out needs for furthering its scientific and engineering infrastructure with new tools to go beyond top performance, Having already delivered systems like Stampede and Blue Waters, they're turning an eye to solving data-intensive challenges. We spoke with the agency's Irene Qualters and Barry Schneider about..
Read more...
Large-scale, worldwide scientific initiatives rely on some cloud-based system to both coordinate efforts and manage computational efforts at peak times that cannot be contained within the combined in-house HPC resources. Last week at Google I/O, Brookhaven National Lab’s Sergey Panitkin discussed the role of the Google Compute Engine in providing computational support to ATLAS, a detector of high-energy particles at the Large Hadron Collider (LHC).
Read more...
05/10/2013 | Cleversafe, Cray, DDN, NetApp, & Panasas | From Wall Street to Hollywood, drug discovery to homeland security, companies and organizations of all sizes and stripes are coming face to face with the challenges – and opportunities – afforded by Big Data. Before anyone can utilize these extraordinary data repositories, however, they must first harness and manage their data stores, and do so utilizing technologies that underscore affordability, security, and scalability.
04/15/2013 | Bull | “50% of HPC users say their largest jobs scale to 120 cores or less.” How about yours? Are your codes ready to take advantage of today’s and tomorrow’s ultra-parallel HPC systems? Download this White Paper by Analysts Intersect360 Research to see what Bull and Intel’s Center for Excellence in Parallel Programming can do for your codes.
In this demonstration of SGI DMF ZeroWatt disk solution, Dr. Eng Lim Goh, SGI CTO, discusses a function of SGI DMF software to reduce costs and power consumption in an exascale (Big Data) storage datacenter.
The Cray CS300-AC cluster supercomputer offers energy efficient, air-cooled design based on modular, industry-standard platforms featuring the latest processor and network technologies and a wide range of datacenter cooling requirements.